Filter
Top Products
7
Connections
Do not plug the power cord into the AC
outlet until all connections are completed.
Connecting to the TV (IPM system)
•
Use the cable included in the package for connection. Connect the stereo audio connection cable as follows:
•
Plug the cables securely. Incomplete connection may cause noise or malfunction.
•
Refer to the manual for your TV or VCR for more information on AV output connections.
•
Be sure to connect fixed output to the “Fixed” audio output jacks. For variable output, refer to the manual for your TV to turn the internal
speakers off.
Lower the volume level on the PHC-5 before you change an input source using the INPUT SELECTOR, since the input level of a device
connected to the VIDEO or AUX input jacks may be different from the input level of the TV and selecting a different input source may
produce a loud sound.
•
Some TVs may output audio signals even if the power is turned off. If such a TV is connected to a VCR that is programmed for recording,
the IPM system may be enabled. To make sure that the IPM system is disabled, turn off the POWER switch on the PHC-5 or connect the
TV output to the VIDEO or AUX input jacks. Refer to the “Connecting to VIDEO/AUX INPUT jacks” section on the next page.
•
When you listen to the TV sound through the unit, turn down the TV volume to minimum. Sound coming from the TV itself may reduce
the surround effect.
To TV’s audio output L ch. jack...white
To TV’s audio output R ch. jack...red
white...PHC-5’s TV input L ch. jack
red...PHC-5’s TV input R ch. jack
CAUTION
What is IPM (Intelligent Power Management) system?
If the TV audio output is connected to the unit’s TV in jacks, turning on (off)
the power to the TV will automatically turn on (off) the power to the unit. This
is called the “IPM system.”
PHC-5
VOLUME
INPUT
AUX
VIDEO
TV
LEVELMAXMIN
FAR
MID
NEAR
DISTANCE
NORMAL
STANDBY/ON POWER
OFF
ON
Therter-Dimensional
WIDE
PANORAMA
SURROUND
VIRTUAL
Audio Output
Audio Output
Audio Input
Variable
L
R
L
R
L
R
L
R
Fixed
Improper connection
Insert completely
PHC-5
TV
Video Cassette Recorder
: Signal flow
PHC-5
*Be sure to connect fixed
output to the “Fixed” audio
output jacks. For variable
output, refer to the man-
ual for your TV to turn the
internal speakers off.
*If you have a video cassette
recorder, connect it to the Audio
Input on the TV or INPUT VIDEO
jack on the PHC-5.
rear panel
Read the
“CAUTION”
described
above.
NOTE