Filter
Top Products
10
Before Operating the PHC-5 System
Using the remote controller
Point the remote controller toward the remote control sensor panel on the unit. Operate the remote controller within the angle
and distance specified in the figure below.
• Do not let strong light, such as direct sunlight or an inverter fluorescent light, strike the remote control sensor panel.
• Do not use the unit with a different remote controller. Otherwise, a malfunction may occur.
• Do not place any object, such as a book, on the remote controller. Otherwise, a button on the remote controller may be held down, which
will waste the batteries.
• An object between the remote controller and the sensor panel on the unit may prevent the remote controller from working.
Adjusting the angle of the unit
You can adjust the angle of the PHC-5 vertically (upward: about 20 degrees; downward: about 10 degrees). Adjust the angle
according to the height of your ears.
R
E
M
O
T
E
C
O
N
T
R
O
L
L
E
R
STANDBY/ON POWER
OFF
ON
The STANDBY indicator lights
up when the unit receives a sig-
nal from the remote controller.
Remote control sensor
30˚
30˚
within approx. 5m
Remote controller
RC-382M
NOTE
If the pivot of the unit is too
tight (or too loose) to rotate,
remove the caps and loosen
(or tighten) the screws using
a Phillips screwdriver.
Be sure to use both hands to
adjust the angle of the unit to
prevent it from falling.
Downward:
Upward: about 20 degrees
Cap
Adjust the angle of the PHC-5
vertically according to the height
of your ears.
about 10 degrees