Filter
Top Products
17
Checking the programmed functions
Check to see if the programmed buttons operate the corresponding device correctly. If pressing one of the programmed buttons
does not cause the SENDING/LEARNED indicator on the remote controller to light up, re-program again.
If the programmed buttons do not enable you to operate the device correctly, review the following:
• The remote controller does not work unless it is close to the device, or the device has a slow response to remote con-
troller operation.
The remote controller signal may not be programmed properly. Re-program the signal again. If the problem persists, check
to see if the battery voltage is low.
• The programmed signal has been erased.
The programmed remote controller signals will be erased if the batteries have been removed for more than 30 minutes. You
need to re-program the signals.
Erasing all programmed functions
Press one of the programmable button to operate the
corresponding device.
If the device does not respond correctly, refer to page 15.
1 Press the LEARN button.
2 Press and hold the POWER button and press the
VOLUME † button.
Hold down both buttons until the SENDING/LEARNED indicator turns off. All
programmed functions will be erased.
SENDING/
LEARNED
POWER
POWER
TV/VCR
POWER
TV/VIDEO
DISTANCE EXPAND
VOLUME
TV CONTROL
VIDEO CONTROL
CH
DISPLAY LEARN
POWER
TV/VCR
POWER
TV/VIDEO VOLUME
TV CONTROL
VIDEO CONTROL
CH
POWER
POWER
TV/VCR
POWER
TV/VIDEO
DISTANCE EXPAND
MODE
TV
SURROUND
FRONT BALANCE
VIDEO
INPUT SELECTOR
VOLUME
AUX
SUB
MUTING
VOLUME
TV CONTROL
VIDEO CONTROL
CH
DISPLAY LEARN
REMOTE CONTROLLER
RC-382M
LEARN
Perform the next step within
fifteen seconds.
VOLUME
POWER