Onkyo MD-105X CD Player User Manual


 
8
Using the remote controller
Inserting the remote controller
batteries
1 Remove the battery compart-
ment cover by opening it as
shown in the illustration.
Using the remote controller
Point the remote controller toward the remote
control sensor.
2 Insert two AA (R6 or UM-3)-size
batteries into the battery com-
partment.
Carefully follow the polarity diagram
(positive(+) and negative (–) symbols) inside
the battery compartment.
3 Replace the compartment cover.
Notes
Do not mix new batteries with old batteries or
differnt kinds of batteries.
To avoid corrosion, remove the batteries if the
remote controller is not to be used for a long
time.
Remove dead batteries immediately to avoid
damage from corrosion. If the remote
controller doesn't operate smoothly, replace
both the batteries at the same time.
The life of the batteries supplied is about six
months but this will vary depending on usage.
MD-105X
Point the remote controller toward
MD-105X’s remote control sensor.
With the supplied remote controller
(RC-409MD)
Remote
control sensor
RC-409MD
30°
30°
5m
Place the unit away from strong light such as
direct sunlight or inverted flourescent light
which can prevent proper operation of the
remote contoroller.
Using another remote controller of the same
type in the same room or using the unit near
equipment which uses infrared rays may cause
operational interference.
Do not put any object such as a book on the
remote contoroller. The buttons of the remote
contoroller may be pressed by mistake and
drain the batteries.
Make sure the audio rack doors do not have
colored glass. Placing the unit behind such
doors may prevent proper remote contoroller
operation.
If there is any obstacle between the remote
contoroller and the remote control sensor, the
remote controller will not operate.