Filter
Top Products
25
Before Using
Connections
Other Information
Operations
Analog recording
1 Press the STANDBY/ON button.
The STANDBY indicator goes out.
2 Load a recordable MD.
To record by erasing all of the existing
tracks on a prerecorded MD
Erase all the tracks before you start
recording (see page 37).
3 Set the INPUT selector to
"ANALOG (MO or ST)" position.
The input source is now set to "Analog".
Monaural recording enables you to record
about twice the duration of stereo recording.
Note
• Make sure that the INPUT selector and
the REC selector on the amplifier are set
to an appropriate recording source.
• Do not change the INPUT selector setting
during recording.
Note
When "Protected" is shown in the display, it
indicates that the record-protect tab of the
MD is open. Before starting the recording
procedure, close the tab. (See page 36.)
To check the time remaining for
recording
When the MD recorder is stopped, press the
DISPLAY button. Each press of the DISPLAY
button changes the display as follows:
The number of tracks on MD and the total
recorded time → Remaining recording time on
MD → Disc name ("No Name" when not set)
DISC LOADING MECHANISM0
REC
DISPLAY EDIT/NO
MINDISC RECODER
AMCS
PUSH TO ENTER
STANDBY/ON
STANDBY
CD
DUBBING
INPUT
ANALOG
ST D1 D2MO
YES
MD-
105
X
12345
678910
11 12 13 14 15
010 2 OVER2040
R
6
L
15
ANALOG IN
(Continued to the next page)
DISC LOADING MECHANISM0
REC
DISPLAY EDIT/NO
MINDISC RECODER
AMCS
PUSH TO ENTER
STANDBY/ON
STANDBY
CD
DUBBING
INPUT
ANALOG
ST D1 D2MO
YES
MD-
105
X
n
oREC
DISPLAY
EDIT/NO
YES
qAMCSw
INPUT
12345
678910
11 12 13 14 15
010 22040
R
6
L
15
ANALOG IN
Total recorded time
Number of recorded tracks
on MD
In analog recording, audio connection cables are used for inputting signals from the recording source.
ANALOG
ST D1 D2MO
STANDBY
STANDBY/ON