Filter
Top Products
50
Symptom
The disc name or track
name cannot be entered.
System function cannot be
used.
Remedy
• Close the record-protect hole (See
page 36).
• Replace it with a recordable disc.
• Check all cable connections. The
system functions cannot be used
even if remote control (z) cables
are connected. Also connect the
components using audio cables.
Cause
• The disc is record-protected
(“Protected” appears).
• A premastered (read-only) disc is
inserted (“Cannot Rec” appears).
• The system functions cannot be
used.
If the unit does not operate properly even after attempting the prescribed remedies, unplug and
then plug in the power cord again.
Troubleshooting (Continued)
Condensation
This is the same phenomena that causes windows to become misted up with water drops in a
heated room during the winter.
The MD recorder also sometimes gets dew (water drops) on the optical lens inside the player under
the following conditions.
• Immediately after you turn a heater on.
• If the MD recorder is placed in a room with full of steam or dampness.
• If you suddenly bring the MD recorder in from the cold outside into a warm room.
If the MD recorder is exposed to dew condensation
You can leave it as it is. Sometimes the recorder cannot read the signal sent from the disc by laser
and the recorder doesn’t work.
Depending on the surrounding conditions you can remove the disc and leave the power on for at
the longest one hour. The dew will evaporate and the recorder will work properly. If it doesn't work
after several hours, please consult the nearest Onkyo authorized service center.