Filter
Top Products
5.0 Update System
5.1 Help About (Fig. 40): When you are ready to download
your configuration to the T2SIR, connect your computer to the
DB9, RS232 port on the back panel of the Tuner. Note that you
may need a USB to RS232 cable if your computer is not
equipped with a serial port. You can click on Help and then
About to confirm communication between the computer and
the Tuner. The initial software screen will appear. If the current
Tuner firmware information is listed in the bottom right-hand
corner of the screen, you have good communication. If it does
not appear, check your cable connections, and make sure the
Tuner is powered on. Often, lack of communication is fixed by
closing and reopening the Configurator.
5.3 Successful Download (Fig. 42): When the download is
complete, a final window will appear indicating that all
information has downloaded successfully. Actual download
time will vary based on your computer’s processing
capabilities.
5.2 Download Configuration (Fig. 41): The final step in the
setup is to download the configuration to the T2SIR via either
its RS232 serial port. A progress bar will indicate the actual
download process.
Fig. 40
Fig. 41
Fig. 42
23
Hardware Information
NV-T2SIR FW v1.01 Hwv00