Filter
Top Products
19
2.1 NuVoNet Operating Mode (Fig. 36): This drop down menu
allows you to select between Standalone or as a NuVoNet
Source 1- 6 . If you are using the Tuner as NuVoNet source
with a NuVo System, you must select a unique, dedicated
source input for each Tuner (A or B) being configured. Stand
alone will set the output for any use other than NuVoNet.
Making the appropriate NuVoNet Source selection properly
sets the Tuner’s outputs for full communication when the
configuration is downloaded to the Tuner.
Fig. 36
2.2 Regional Setup (Fig. 37): Depending on your geographic
location, the Tuner needs to be set for the proper tuning
standard. The choices are USA & Canada, Western Europe,
Australia, and New Zealand. Countries outside these
geographic locations need the advanced custom setting (see
section V. Advanced Settings: 4.1 Custom Regional Setup,
pg.21). Note that the NV-T2SIR is specifically designed for USA
and Canada use. AM/FM reception will work worldwide, but
SIRIUS is only available in North America.
Fig. 37
2.3 Brightness (Fig. 38): This sets the intensity of the display
for the Tuner. The factory default is the maximum level, 8.
Fig. 38
2.4 Auto-On (Fig. 39): In the event of loss of power, or if the
Tuner is unplugged, the Tuners can be set with this check box
to automatically turn on when power is restored. Note that this
feature is only necessary for non-NuVoNet use, since NuVoNet
causes the Tuners to turn on when a zone within the NuVo
System is turned on. The Tuners will turn off when all NuVo
System zones are turned off.