Filter
Top Products
13
T2SIR Settings (Fig. 18)
There are several operational defaults that are set in this menu
choice:
Operating Mode (Fig. 19): This will display the set
choice for each Tuner output A and B with a check
mark. The choices are Standalone, Source 1, Source 2,
Source 3, Source 4, Source 5, and Source 6. Here, the
source number or standalone can be changed from the
initial power on setting. Unavailable NuVoNet sources
will be grayed out.
Enabled Bands: Broadcast bands associated with each
Tuner can be turned off here. This is useful especially
for AM where an acceptable AM signal is not possible.
If SIRIUS is disabled, all SIRIUS related menu items
will be removed as opposed just being grayed out.
Tuning: There are four sub-menus that set default
tuning parameters for the T2SIR:
Fine Tuning: This reduces the frequency step
to 50 kHz in FM and 1 kHz in AM. With today’s
digital Tuners, this feature is rarely used.
Regional Setup: Regional Setup sets the
default tuning standard for four regions of
the world. The choices are US/Canada,
Western Europe, Australia, and New Zealand.
Custom is grayed out. This must be set using
the Configurator Software discussed later in
this manual.
Seek Thresholds (Fig. 20): The recognized
signal level for AM and FM can be set in this
menu. There are three default levels with 1
being the lowest, requiring a stronger signal
to be recognized and 3 being the highest,
requiring a weak to moderate signal to be
recognized. The default is 2, the middle level.
Brightness: Brightness sets the overall level
of the display. There are seven degrees of
brightness to choose from.
Fig. 18
Fig. 19
Fig. 20
T2SIR Settings
Operating Mod
Enabled Bands
Tuning
Operating Mode
Tuner A
Tuner B
Set Tuner A Mo
Standalone
Source 1
Source 2
Seek Thresholds
AM Threshold
FM Threshold
AM Threshold
Level 1
Level 2
Level 3