Filter
Top Products
Re-Ordering Macro Codes
After a code is added to a macro, highlighting a code and
clicking on the Ý or ß button will reorder the codes.
Macros (updated)
After editing a macro, the macro list is updated to show the
number of IR codes and the display name.
Note that the Macro tab has an additional button at the
bottom that says Update Macros From Library. If codes
were edited in any way in an IR library after a source has
been defined in the Source tab, this button will
automatically pull those changes into the Macro Definition
window.
4.1.3 Control Macros
An additional option within the Macro tab is the ability to
establish multiple control macros. These macros are
intended for instant access to control functions and are an
optional feature. If a control macro is created, an additional
source menu item is also created titled Control preceded
by the three character short name assigned in the Source
tab.
Creating a control macro is the same process outlined in
4.1.1 Creating a Preset Macro String on page 17.
18
5. Zones (Fig. 24)
Up to 20 zones can be defined with the Grand Concerto. Each
zone can be defined with unique properties.
You will notice that the zone tab contains 20 entries for zone
Control Pads. The system can accommodate a total of
20Control Pads by using the slave function in the Edit Zone
Properties window. A slave Control Pad is homerun to the EZ
Port, but automatically shares the same functions and works
in tandem with the main zone Control Pad. Up to three slave
Control Pads can operate on a single zone.
Fig. 24
5.1 Edit Zone Properties (Fig. 25)
Double-clicking on a zone number opens the Edit Zone
Properties window. Specific properties defining that zone
are set here.
Max Volume: This allows the volume in a zone to be limited.
This can be done either to avoid damage to low-power
speakers or simply to prevent a certain room from being
turned up too high (e.g., a teenager’s bedroom).
Party Volume: This controls the reset volume level for each
zone when the All On/Party Mode is initiated from any of the
Control Pads. The range is 78dB to 30dB.
Page Volume: If you are using the paging feature of the
Grand Concerto System, you can also set the specific volume
level of the page zone by zone, by using this volume control.
The range is 78dB to 30dB, with a default at 40dB.
Balance: The level of output to the left and right speakers is
adjusted here. The default is center, but depending on the
location of the speakers and the optimal listening area of
the room, it may be advantageous to adjust the balance to
either the left or the right.