Filter
Top Products
15
2.6 Adding a Function Code (Fig. 17)
If a required IR function is not in the list of those provided in
the library template, it is possible to add a code to the list
by clicking the Create New button. The pull-down menu
contains a list of all standard IR codes. A name not found in
the list can be typed in, but it is recommended that you use
the names provided in the list. This conserves memory in the
Grand Concerto. Clicking on the OK button proceeds
directly to the IR recording process.
Fig. 17
2.7 Cleaning Up an IR Library
Unused IR codes can be deleted from the list by highlighting
the code and either clicking the Delete button or right-
clicking and selecting Delete.
When you are finished editing the library, select Done.
3. Defining Sources
The Sources tab allows you to define the source
component attached to each of the six source inputs. All six
sources are not needed, but at least one source must be
defined.
3.1 Select or Edit Source (Fig. 18)
Double-clicking on a blank source will open the Select
Source window. This window assigns the appropriate source
number input. The Display Name is the text that will be
read on the Control Pad when that source is selected in any
zone. The display name can contain only capital letters,
numbers, and some punctuation. If an invalid key is typed, it
will be ignored.
The Make field defines the manufacturer of the
equipment. A drop-down menu allows you to choose a
source from the IR Library. The Model field provides a
drop-down menu that allows you to choose the specific
piece of source equipment from the selected manufacturer.
An important feature of the Select Source window is the
Gain level control. Different pieces of source equipment
tend to have different levels of audio output signal. This
slider control allows you to compensate for equipment that
has an inherently lower volume level. By using this
adjustment, when switching between sources, relative
volume levels remain constant.
When the appropriate information has been completed, click
OK. This will add the updated source information to the
Source window. When all the desired sources have been
defined, go to Next and proceed to the Macros setup.
Fig. 18