Filter
Top Products
SYSTEM
ZONE TRIGGER OUTPUTS
EMITTER OUTPUTS
SYS ON
EXT. MUTE
SUM1
1 3
5
7
8
1
3 5
2
4
6
SUM2
2 4
6
6
SYSTEM
ZONE TRIGGER OUTPUTS
EMITTER OUTPUTS
SYS ON
EXT. MUTE
SUM1
1 3
5
7
8
1
3 5
2
4
6
SUM2
2 4
6
6
dISC
COMPACT
10
M3 Server
At initial startup, the front panel display will prompt with
OUTPUTA: PRESS OK TO SELECT NUVONET SOURCE. When OK is
selected, the top line of the display will read OPERATING
MODE OUT A. Below this, the three available lines will display
STANDALONE, SOURCE 1, SOURCE 2 . . . as you scroll using the
down arrow button, SOURCE 3, SOURCE 4, SOURCE 5, and
SOURCE 6 will appear. Highlight the appropriate choice and
press OK to select. This will set the first channel music
output. You will then be prompted to repeat these steps for
the remaining two audio outputs, B and C.
VII. Connecting the IR Emitters for Third-Party Source
Components (Fig. 6)
IR commands for the source equipment are transferred from
the Grand Concerto amplifier to the source equipment using
the mini IR mouse emitters. Six of these are supplied with
the Grand Concerto System. The emitter is plugged into the
corresponding source IR output on the Grand Concerto and
then placed over the IR receiver window on the source
component. The IR outputs are individually routed to
sources 1-6.
The SUM1 and SUM2 outputs will flash any IR command that
is sent from any of the zones. This is most commonly used
with an IR blaster designed to flash IR commands to a
variety of components.
NuVo T2G Tuner Direct Numeric Access (Fig. 7)
The NuVo T2G Tuners have the ability for direct IR access to
numeric station tuning. This can be done through the T2G
remote control or using a third party remote control that has
been taught the T2G IR codes. To allow this control, it is
necessary to link one of the Grand Concerto SUM IR outputs
to the Direct IR input on the T2G using a stereo 3.5mm
(1/8 ) mono patch cable. Once the connection is made, the
T2G will respond to the numeric IR commands issued
through the Grand Concerto Control Pad IR receivers.
Fig. 6
Fig. 7
NuVoDock for iPod
Both the wired and wireless NuVoDocks for iPod use a simple
rotary switch to set the appropriate source input. Up to two
wireless NuVoDocks and 6 wired NuVoDocks can be used as
individual sources through NuVoNet. The wired and wireless
NuVoDocks consist of the dock for iPod playback and
recharging and a receiver component designed to
communicate with NuVoNet. Prior to plugging the receiver
into the Grand Concerto EZ Port, set the Source rotary switch
to the desired source number input. Once set, the Grand
Concerto Control Pads will automatically display the iPod
information when an iPod is plugged into the NuVoDock.
Each NuVoDock and receiver must have a separate source
number selected.
Note that although the NuVoDock system has a 16 position
rotary switch for source input, only positions 1-6 are used.
RS 232
Model NV-T2DF
Dual XM Tuner
NuVo Techonlogies LLC•
Cincinnati Ohio USA
www.nuvotechnologies.com
SYSTEM
IR PASS-THRU
IR INPUT
NuVoNet
OUTIN
USB
T2G Tuner IR Input
Grand Concerto IR Ouput