Filter
Top Products
5-14 Procedures after Completion of Installation
CAUTIONS FOR APPLYING Windows Service Pack
Do not use your own judgment and apply the Windows Service Pack to the NEC Express5800/ft
series.
IMPORTANT:
If you desire to apply service packs, contact your sales agent about the application status,
and apply service packs to NEC Express5800/ft series.
CHANGING THE COLOR QUALITY OF DISPLAY TO 32 BIT
The default color quality of the graphics driver is set to 16 bits for the NEC Express5800/ft series.
The server rarely displays the following message when accessing a floppy disk and becomes unable
to access the floppy disk. The default color quality is 16 bit to prevent that from happening.
The volume does not contain a recognized file system. Please make sure that all required file system
drivers are loaded and that the volume is not corrupted.
Even if this message is displayed and the server becomes unable to access the floppy disk, the
processing completes by accessing the floppy disk again.
If you need to change the color quality to 32 bit knowing this limitation, apply a special graphic
driver as described below:
(1) Log on to Windows Server 2003 as a user with administrator authority.
(2) Set the “NEC EXPRESSBUILDER” CD into the CD-ROM drive.
(3) From the Start menu, select [Run...].
(4) Enter “D:\HAS\W2K3\GA32SET.BAT” in the “Open” box (replace “D” with the drive letter
of the CD-ROM drive), and click [OK].
Then, restart the server.
To change the color quality to the standard (16 bit), perform the above steps but run
“GA16SET.BAT” in (4) instead of “GA32SET.BAT.”