Filter
Top Products
Setting up the compact disc player
19
To connect to other Meridian 500
Series equipment
● Connect one of the COMMS sockets on the back panel of the
compact disc player to one of the COMMS sockets on
another 500 Series unit, using the 500 comms lead provided
with the other unit.
The sequence in which you connect the units is not important.
507 Compact Disc Player 500 Series unit
COMMS COMMS
Then configure the units with the following automatic setup
procedure:
● Switch all the units to standby.
● Press Clear on the remote.
Each unit will display:
Auto
One unit will then be designated
as the controller, and display:
Con.
This is the unit that will respond to the remote.
All the other units will be configured
as non-controllers, and display:
N.Con.
Your system is now set up and ready for use.
If for any reason the automatic setup does not give the
configuration you want, restore the default operation by
selecting the standard type; see Choosing standard settings,
page 24.
Note: Do not, under any circumstances, connect any equipment
other than Meridian 500 or 800 Series to the socket marked
COMMS on the back of the compact disc player.