Mark Levinson 500H Stereo Amplifier User Manual


  Open as PDF
of 32
 
Mark Levinson
20
Troubleshooting
Incorrect operation is sometimes mistaken for malfunction. If
problems occur, use this section for troubleshooting information. If
problems persist, contact your authorized Mark Levinson dealer.
1. Examinethepowercordtoensurethatitisconnectedtoboth
the rear panel connector of the amplifier and an electrical
outlet.
2. Make sure the amplifier is powered on with the Power switch.
3. Make sure the amplifier is not in Standby mode. The front
panel LED should be at full brightness.
4. Examinetheelectricalcircuitbreakertoensurethatpower
is being supplied to the electrical outlet to which the amplifier
is connected.
5. Verifythatthevoltageratingontherearpaneloftheamplier
matches the voltage rating of the electrical outlet. If the
voltages do not match, no power is sent to the outputs of
the amplifier.
1. Make sure that the source device is powered on, playing audio,
and set to the right output connector.
2.Examinecablestoensureasolidconnectionbetweenthe
amplifier and associated components.
3. Make sure the amplifier's output connectors are connected to
operational loudspeakers.
4. Ensure that the amplifier is not in a fault condition. When the
amplierexperiencesafault,theoutputismutedandtheStatus
LED on the front panel blinks in a rapid pattern, indicating:
LED Behavior Description
Rapidly blinking
(on most of the time)
Indicates that a power-related fault has
occurred.
Rapidly blinking
(on half of the time)
Indicates that a signal-related fault* has
occurred.
Rapidly blinking
(off most of the time)
Indicates that a thermal-related fault has
occurred.
*Signal-related faults include significant DC offset at the output due to either DC in the input
signal or a failed component within the amplifier OR excessive current demands due to a
short-circuited loudspeaker wire.
Youmustassigntheslavefromthemasterdevice.Verifythatthe
slave you want to assign is listed in the master device list and
checkitscurrentstate.Forfurtherexplanationsonassigningslave
devices, refer to the owner’s manual of the master device.
No Power
No Output
Can’t Assign in ML Net
 previous next