Mark Levinson 500H Stereo Amplifier User Manual


 
Mark Levinson
14
If DHCP is not used, then the computer must be set up too. Use
thisproceduretosetupthecomputer,thencontinuetothenext
procedure to connect to the amplifier. For the computer to find
theamplier,theLAN(LocalAreaNetwork)andTCP/IP(Internet
Protocol) settings of the computer must be set up. The parameter
setups vary slightly depending upon the operating system of the
computer. Refer to the procedure below that matches the operating
system on your computer.
Due to your preference settings in the Windows operating system,
the names and order of the dialog boxes may vary slightly from these
instructions.
Network Setup for Windows XP
1. From the Start menu, select Control Panel.
2. Double-click on the Network Connections option.
3. Double-click on the Local Area Connection option.
4. Click the Properties button to open the Local Area Connection
Properties menu. If the computer is not currently connected
to an active network, Step 3 has already opened the Local Area
Connection Properties menu.
5. ClickontheInternetProtocol(TCP/IP)lineitemsothatitis
highlighted.
6. Click the Properties button.
7. Selectthe“UsethefollowingIPaddress”option.TheIP
address,Subnetmask,andDefaultgatewayboxesarenolonger
grayed out and can now be modified.
8. Enter the following values:
•IPaddress:192.168.50.x–wherexstandsforanumber
other than 0, 3, 4, 5 or 255
•Subnetmask:255.255.255.0
•DonotenteravalueintheDefaultgatewayparameter
The computer must have a unique address and be on the same
subnet as the amplifier.
9.Click“OK”tosaveandexitthemenu.
10.OpentheInternetExplorerWebbrowser.
11. From the menu bar, select the Tools Internet Options menu.
12. Select the Connections tab.
13. Click the LAN Settings button.
14.Verifythat“UseaproxyserverforyourLAN”isNOTchecked.
15.Click“OK”tosaveandexitthemenu.
Setting Up the
Computer
Note