Filter
Top Products
19
Nº500H Series Power Amplifier
The figure below illustrates a typical ML Net setup:
Before the master device can control any slave device, the slave
devicesmustbe“discovered”andassignedtothemasterdevice.
Refer to the Owner’s Manual of the designated master device for
further information about discovering and assigning slave devices.
The Nº500H series slave(s) can report the following status
information to the master device:
• Temperature – the current operating temperature of the
amplifier(s).
• Session Time – the amount of time that the amplifier(s)
has been powered on.
• Total On Time – the total amount of hours that the
amplifier(s) has been powered on since its manufacture.
If a slave device is inactive, unassigned, or assigned to a different
master, then status information is not available.
The Nº500H series slave(s) also reports fault information to the
master device. If a slave device is inactive, unassigned, or assigned
to a different master, then error reporting is not available. For more
information about possible fault conditions, refer to the
“Troubleshooting”sectionofthemanual.
Router
Nº500 Series
Power Amplifier #1
(Slave)
Nº500 Series
Power Amplifier #2
(Slave)
Nº500 Series
Power Amplifier #3
(Slave)
Nº500 Series
Power Amplifier #4
(Slave)
Nº532 Media Console
(Master)
Discovering Slaves
Status Reporting
Fault Reporting