Filter
Top Products
10
English
English
OPERATION
PLAYBACK
PLAYBACK ON ONE WELL (Same procedure for Well
A or Well B) OR BOTH WELLS
1. Set the POWER button to ON.
2. Insert a prerecorded cassette in the cassette holder(s).
3. Reset the tape counter by pressing the RESET button.
4. If the tape has been encoded with Dolby NR, set the DOLBY
NR switches accordingly.
5. Press the PLAY
button to play the cassette.
6. Press the STOP
button to stop playback.
CONTINUOUS PLAYBACK
1. Set the POWER button to ON.
2. Insert recorded cassettes into both Wells.
3. If the tape has been encoded with Dolby NR, set the DOLBY
NR switches accordingly.
4. Press the CONT button to select the continuous mode. The
lighting of the CONT indicator indicates the "
" mode and
the blinking indicates the "
" mode.
5. Press one of PLAY
buttons. Playback will start. When that
Well finishes playing , the second well will begin playing.
6. When the continuous mode is "
", the tape stops after the
second well is finished or triggers another deck via the EXT
output.
7. When the continuous mode is "
" and the AUTO REW mode
is on, the tape in the first well that has been rewound is played
after the second well is finished.
8. Press the STOP
to stop playback.
9. Press CONT to cancel CONT mode.
Note:
During continuous playback, the signal from both wells goes
to line output A.
TIMER PLAYBACK (Same procedure for Wells A and B)
1. Connect the power cord of this unit to a timer.
2. Insert a prerecorded cassette in the cassette holder(s).
3. If you wish to use Dolby NR, set the DOLBY NR switches to
select B- or C-type noise reduction.
4. Set the POWER switch of this unit to ON.
5. Set the TIMER switch to the PLAY position.
6. Set the timer to the desired time.
7. When the set time comes and the timer turns on, power is
supplied to the unit and playback starts automatically.
Note:
Use a timer which can turn on at the desired time of the day.
RECORDING
SINGLE WELL RECORDING
(Same procedure for Well A or Well B)
1. Insert a blank cassette into the cassette holder(s).
2. Reset the tape counter by pressing the RESET button.
3. If you wish to use Dolby NR, set the DOLBY NR switches
accordingly.
4. Press the REC
button to enter REC-PAUSE mode.
5. Adjust the record level using the REC LEVEL control, so that
the red LEDs light only at peaks in the music.
6. Press the PLAY
button to initiate RECORD.
7. Press the STOP
button to end recording, or press REC
again to re-enter REC-PAUSE mode.
Note:
Be aware of the setting of the input select switch on the rear
panel.
¡ A, B Position : Well A receives input from input A, Well B
receives input from input B.
¡ A Position : Both wells receive input from input A.
Tape Types and Length
Any type of tape (Normal, High, or Metal) can be used with the
PMD520. High or Metal tapes have superior performance com-
pared to Normal Tapes. The PMD520 can sense which kind of
tape is being used, and will automatically adjust bias, EQ, etc.
C-60 or C-90 length tapes are recommended, as C-120 tapes
are often too thin, and can become entangled in the transport
mechanism.
Remote Operation
The period
(00.00)
of the time display will flash depending
on which Well is being addressed by a conected remote con-
trol.