Filter
Top Products
9
English
English
!3!3
!3!3
!3 TIMER
This switch is used to set the timer operation mode.
¡ OFF
No timer operation is used when the switch is set to this
position.
¡ REC
Timer recording operation is activated when the switch is
set to this position. The tape will automatically start record-
ing when the power is switched on.
¡ PLAY
Timer playback operation is activated when the switch is
set to this position. The tape will automatically start playing
when the power is switched on.
!4!4
!4!4
!4 REC LEVEL CONTROL
For adjusting the record input level.
!5!5
!5!5
!5 REC BALANCE CONTROL
Used to adjust the left-right balance of channels while re-
cording.
!6!6
!6!6
!6 FINE SPEED
Each well features ±3% speed control.
!7!7
!7!7
!7 PHONES SELECTOR SWITCH
This switch allows you to select Well A, Well B, or a mix of
both Wells (A+B) in the phones.
!8!8
!8!8
!8 PHONES LEVEL CONTROL
This control adjusts the volume of the headphone output.
!9!9
!9!9
!9 PHONES JACK
Use this jack to connect a pair of headphones with a stereo
1/4" connector.
DISPLAYS
aa
aa
a TAPE TIME COUNTERS
These counters display the tape position for each Well in
Minutes and Seconds.
bb
bb
b BARGRAPH LEVEL METERS
These meters display the signal levels for each Well in ste-
reo.
cc
cc
c AUTO REW INDICATOR
These indicators will light up when the AUTO REW mode
button t is pressed.
dd
dd
d CONT (CONTINUOUS) INDICATORS
These indicators will light up when the CONT mode button
y is pressed.
ee
ee
e A+B INDICATOR
These indicators will light up when the A+B mode button u
is pressed.
ff
ff
f TAPE SPEED INDICATORS
¡ HIGH SPEED INDICATOR
This indicator will light up when the HIGH SPEED mode
button i is pressed.
¡ NORMAL SPEED INDICATOR
This indicator will light up when the NORMAL SPEED mode
button i is pressed.
gg
gg
g OVERLAP RECORDING INDICATOR
This indicator will light up when the OVERLAP REC mode
button o is pressed.
hh
hh
h MONITOR INDICATORS
These indicators will light up when in the TAPE MONITOR
mode.
ii
ii
i BIAS RESET INDICATORS
These indicators will light up after the BIAS RESET program
is run.