Filter
Top Products
5
ENGLISH
PART NAMES AND FUNCTIONS
REAR PANEL
a FM antenna terminal (75 ohms)
Connect an external FM antenna with a coaxial cable, or
the supplied FM indoor antenna.
b AM antenna and ground terminals
Connect the supplied AM loop antenna. Use the
terminals marked “AM” and “GND”. The supplied AM
loop antenna will provide good AM reception in most
areas. Position the loop antenna until you hear the best
reception.
c XM terminal
See page 14 for connecting information.
d ANALOG OUT 1, 2 (analog output)
connectors
The audio signals are output from these connectors.
e
RS-232C
The RS-232C port is to be used in conjunction with an
external controller to control the operation of the ST7001
by using an external device.
f
FLASHER IN (Flasher input terminal)
This terminal is to control the unit from another zone.
Connect the control signal from a Keypad, etc.
g
REMOTE CONTROL IN and OUT connectors
Using the supplied remote control connecting cord,
these connectors enable this unit to be connected to a
Marantz component equipped with remote control
connectors. These connections make it possible to
control an entire system that centers on the amplifier or
other such component.
h EXTERNAL/INTERNAL switch
Before the unit was shipped from the factory, this switch
was set to INTERNAL to enable the remote sensor built
into the unit to be used.
Before using the supplied connecting cord to make the
connection between the unit and the remote control
connectors on a Marantz equipment, set the switch to
EXTERNAL.
Note
• Signals cannot be received from the remote control
unit if the switch is kept at EXTERNAL when the unit is
to be used on its own.
i AC INLET
Plug the supplied mains cord into this AC INLET and
then into the power outlet on the wall.
ST7001 can be powered by 120V AC only.
j AC OUTLET
Connect the AC mains cord of components such as a
MD or Tape Deck to this outlet. This SWITCHED outlet
provides power only when the ST7001 is turned on.
Caution
• In order to avoid potential turn-off thumps, anything
plugged into this outlet should be powered up before
the ST7001 is turned on.
• The capacity of this AC outlet is 100W. Do not connect
devices that consume electricity more than the
capacity of this AC outlet.
ANTENNA
FM(75
Ω
) GND AM
XM
21
L
R
ANALOG OUT
AC OUTLET
OUT
IN
EXTERNAL
INTERNAL
R
L
RS-232C
MODEL NO. ST7001
FLASHER
IN
SWITCHED
100W MAX
REMOTE
CONTROL
AC IN
agc d e f h i jb