Filter
Top Products
6
ENGLISH
PART NAMES AND FUNCTIONS
REMOTE CONTROL UNIT
For details on the functions of these parts, refer to the pages
given in parenthesis (
☞
page 10 ~ 22).
z STANDBY button
Press this button to switch from the operating mode to
the standby mode.
x Preset channel buttons (1 ~ 10)
Use these when presenting and recalling stations. Also
use these with the SHIFT ,MEMORY GROUP button to
use a total of 200 preset channels (FM/AM 100 , XM
100), A (1 ~ 10), B (1 ~ 10), ... J (1 ~ 10).
c BAND button
This button is used to select XM, FM or AM.
v ENTER button
This button is used to set the menu.
b A-PRESET/A-TUNE button
When pressed in the FM mode, receivable FM/AM
stations are automatically stored in the preset memory in
order starting from preset channel A1.
n MEMORY GROUP buttons (A/B, C/D, E/F,
G/H, I/J)
Use these buttons to switch the preset channel’s shift
mode directly.
m SLEEP button
This button is used for setting the sleep timer. (
☞
page
22)
, ON button
Press this button to switch from the standby mode to the
operating mode.
. DISPLAY button
This button is used to switch XM information such as
artist name/song title, category or signal status.
Available only when the unit in the XM Satelite Radio
mode.
⁄0 DIMMER button
The display’s brightness switches (in three levels) each
time this button is pressed.
⁄1 TUNING buttons
Use these to change the received frequency/XM channel
to a higher frequency/XM channel (+) or a lower
frequency/XM channel (–).
⁄2 MENU button
This button is used to enter/exit menu mode.
⁄3 SHIFT button
Use this button to select the memory groups, A (1 ~ 10),
B (1 ~ 10), ... J (1 ~ 10).
⁄4 CHANNEL/CONTROL button
This button is used to select radio presets or select
stations and menu options.
⁄5 T-MODE button
Selects the stereo mode or mono mode when a FM
stereo broadcast is received. (
☞
page 10)
⁄6 MEMO button
Frequencies and station names can be stored in the
memory. When this button is pressed, the Preset
channel number on the display flashes for 10 seconds.
Use the SHIFT button and the Preset channel buttons
during this time to designate the desired preset channel.
⁄7 TIMER button
This button is used to enter the timer program mode.
Clock setup mode can be entered by holding down this
button for 3 seconds or more. Please refer to page 20 for
TIMER program operation.
REMOTE CONTROLLER
RC7001ST
/A-TUNE
A-PRESET
SHIFT
R
E
E
N
T
BAND MENU
TUNING
CONTROL
CHANNEL/
A/B C/D E/F
TIMER
10
DISPLAYDIMMER
987
456
32
T-MODEI/JG/H
SLEEP MEMO
ONSTANDBY
1
z ,
⁄2
⁄3
⁄4
⁄5
⁄6
⁄1
.
c
b
m
n
v
⁄0
⁄7
x