Filter
Top Products
7
ENGLISH
7
Remote control code setting
The remote control unit contains 3 sets of remote control
codes, and it can be used to control up to 3 tuners in one
location. To control a second or third tuner, select the
remote control code as explained below. The selected tuner
can be operated from the remote control.
• When the unit is shipped from the factory, the main unit
and remote control are set to TUNER1.
1. TUNER2
To set the remote control to TUNER2, hold down both
the SHIFT button ⁄3 and 2 number button x on the
remote control for at least five seconds.
TUNER3
To set the remote control to TUNER3, hold down both
the SHIFT button ⁄3 and 3 number button x on the
remote control for at least five seconds.
2. Also set the main unit's remote control setting to the
same setting as the remote control. To change main
unit's remote control setting, hold down both the SHIFT
⁄3 and DISPLAY . buttons on the remote control; the
remote control setting (“TUNER1”, “TUNER2” or
“TUNER3”) will be displayed in the display window on
the main unit and main unit setting will be changed same
setting as remote control.
Note
• To set the remote control back to TUNER1, hold down
both the SHIFT button ⁄3 and 1 number button x on the
remote control for at least five seconds.
• If the batteries in the remote control are replaced while the
remote control is set to TUNER2 or TUNER3, the setting
will revert to TUNER1.
• If the main unit is unplugged the mains cord, the remote
control setting will revert to TUNER1.
PART NAMES AND FUNCTIONS
REMOTE CONTROLLER
RC7001ST
SHIFT
R
E
E
N
T
BAND MENU
TUNING
CONTROL
CHANNEL/
A/B C/D E/F
TIMER
10
DISPLAYDIMMER
987
456
32
T-MODEI/JG/H
SLEEP MEMO
ONSTANDBY
1
/A-TUNE
A-PRESET
⁄3
.
x