Filter
Top Products
5
ENGLISH
NAMES AND FUNCTIONS OF PARTS
wq
uio!0!1!2 yt r e
FRONT PANEL
q ON/STANDBY button
Press this button to turn on the power.
When it is pressed again, the unit goes
into standby mode and the STANDBY
indicator i lights.
w Display window
Normally, the volume level indication (00-
60) is displayed.
e VOLUME + button
Press this button to increase the volume.
Keeping this button pressed increases the
volume successively.
r VOLUME – button
Press this button to decrease the volume.
Keeping this button pressed decreases
the volume successively.
t SUB WOOFER indicator
The indicator lights in green when
subwoofer output is activated by pressing
the SUBWOOFER button on the remote
controller.
The indicator goes out when subwoofer
output is set to off by pressing the
SUBWOOFER button on the remote
controller.
The subwoofer output is set to on and the
indicator is lit as the factory-setting mode.
Note:
Before installing this unit, connect a
commercially available or optional Marantz
subwoofer with a built-in amplifier.
y NIGHT MODE indicator
The indicator lights in green when the
night mode function is activated.
The indicator goes out when the night mode
function is canceled by pressing the NIGHT
MODE button on the remote controller.
Note:
The night mode function can be activated
only when the Dolby D (Digital) indicator
is lit blue.
u MODE indicator
The indicator lights in blue when the
binaural mode is activated. The indicator
goes out when the binaural mode is
canceled by pressing the MODE button on
the remote controller.
Note:
The binaural mode can be set when an
audio source recorded in binaural mode
is played.
i STANDBY indicator
The indicator lights in red when the unit is
in standby mode.
o Dolby PL II indicator
The indicator lights in green when 2-
channel signal is input and the Dolby Pro
Logic
II mode is set to Pro Logic II MOVIE
or Pro Logic
II MUSIC.
When Dolby Pro Logic
II mode is set to
OFF by pressing the Dolby PL
II button
on the remote controller, this indicator
goes out.
!0 Dolby D indicator
When a Dolby digital signal is input, this
indicator lights in blue.
!1 dts/AAC/PCM indicator
The indicator lights in the following colors
according to the format of digital signal
input from the connected equipment:
dts signal: red
AAC signal: yellow
PCM signal: green
The indicator goes out when the A1 or A2
button on the remote controller is pressed
to select an analog input signal.
!2 INPUT SELECTOR button
Press this button to select the input source
to be played.
Each press of the button changes the
indication in the display window as shown
below.
The factory-preset setting is “d1.”
A2 (AUX)
A1 (VCR)
H2(HDMI 2)
H1(HDMI 1)
d1(DVD)
d2 (TV)
d3 (GAME)