Filter
Top Products
14
ENGLISH
to input jack to control
input jack
SW7001 subwoofer
with a built-in amplifier
(optional)
SUB W. PREOUT
SUB W. CONTROL
OUT
Right side of the unit
STANDBY
PAUSE
HDMIAUDIO EX.
HDMIAUDIO EX.
OPEN/CLOSE
STOPPLAY
POWER
ON/OFF
IN
INT
EXT.
OUT
Marantz CD/DVD player
to remote
control input
Remote control
switch
REMOTE OUT
Right side of the unit
CONNECTIONS
CONNECTING A SUBWOOFER
• For connection with the optional SW7001 subwoofer, use the connecting cable supplied with
the SW7001.
• If the power of the SW7001 is turned on after connection, it will be turned on or goes into
standby mode in conjunction with the operations of the unit. This function is not available with
other manufacturers’ subwoofers.
7 Connections
• Connect the SUB W. PREOUT jack on the unit to the input jack on the SW7001.
• Connect the SUB W. CONTROL OUT jack on the unit to the control input jack on the
SW7001.
REMOTE CONTROL CONNECTIONS
• The REMOTE OUT jack is used for connection with the Marantz DVD player, etc. equipped
with remote control output.
• When the Marantz DVD player or the IS201 is located in a place where the infrared beam
cannot be easily received, make a remote control connection. When you operate the remote
controller pointing toward this unit, a received command signal is transmitted to the connected
equipment.
7 Connections
• Connect the Marantz DVD player to the REMOTE OUT jack on the unit using the remote
control cable supplied with the player.
Note:
For this connection, set the remote control switch on the rear panel of the connected
equipment to EXT.