Filter
Top Products
27
ENGLISH
Recording is distorted
• make sure the recording level was not too high
• check that the disc is not defective by trying another disc
20 second pause between recordings
• see ‘RECORDING’ SYNC on page 14
Player does not react
• use the
POWER ON/OFF
(1) button on the front of the
Player to switch it off and back on
on display
• a power failure has occurred during recording the CD-
Recorder is attempting to repair the disc
• If
then appears on the display, the disc
cannot be recorded further, and cannot be Finalized.
But it can still be played on the CDR500 or another CD-
Recorder.
• on a CD-R/RW disc, the track being recorded is lost, but
further recording and finalisation can still be done
• check that the disc is not defective by trying another disc
XLR input level is too low or too high
• adjust the R and L TRIM pots on the back panel to the
optimum level
Digital input source indication is flashing
• check the digital cable connections
• check that the output of the digital source is conforms to
the SPDIF (or IEC-958-II) standard
• try a different cable to make sure the digital cable is OK
Recorded disc playback quality on other CD players is poor
• make sure to use good quality discs when recording audio
• make sure the discs used for recording are compatible
with 1X speed recording
• try recording onto a 'Music' (consumer) type blank disc
because they are specially designed for 1X speed audio
recording
• If using 80 minute discs, try a 74 minute disc because
they provide a wider recording area and thus have a less
chance for error
CD-Text appears on CD-Player but not on CD-Recorder
• the CD-Recorder drive does not display the CD-Text on
“hybrid” CDs that contain audio and data together on the
disc.
OTHER INFORMATION
The numbers between parentheses refer to the fold-out.
CDR500U ENG 22-27 10/11/00, 9:35 AM27