Filter
Top Products
54
Programming PAV Functions If you inadvertantly overwrite one or more PAV commands in your PAV remote
control, never fear—you don’t have to obtain another PAV remote in order to re-
teach your own its PAV-specific commands. The PAV itself can send all of the nec-
essary IR commands from its main display window, enabling you to teach the
PAV remote both its pre-programmed commands and a few other, optional com-
mands which you might find useful.
When using the PAV itself to teach new commands to your remote control, your
remote will have to be in its learning mode (obviously). Therefore, you must
navigate the on screen menus by using the buttons on the front panel of the PAV.
The buttons on the front panel you need to use are as follows:
• recall: the menu function is provided by the recall button. In order
to activate the on screen menus rather than simply recalling the
calibrated output level settings, press and hold the recall button un-
til the front panel lights are turned off (about ten seconds). From
this point on until you exit the menu system, the recall button will
perform exactly as the menu button on the remote control would.
• master: the front panel master button is also conveniently placed
adjacent to the volume +/– buttons, and serves the same purpose
as the one on the remote control.
• volume +/–: the front panel volume +/– buttons also operate in
the same fashion as their counterparts on the remote control.
• standby: the enter function is provided by the standby button on
the front panel (when the PAV is in menu mode). It is deliberately
set apart from all of the other menu-related buttons to make per-
manent changes of system parameters a deliberate act.
1 ENTER THE SETUP MENU
2 SELECT “REMOTE CONTROL,” AND THEN “TEACH REMOTE”
3 TO RE-LEARN THOSE FUNCTIONS WHICH HAVE CORRESPONDING
FRONT PANEL BUTTONS, CHOOSE “PANEL BUTTONS”
The on screen display will prompt you to press any button. Line up the IR
window of the PAV remote control with the center of the main display of
the PAV, at a distance of approximately 6"-12". Select the to-be-learned but-
ton on the remote, then press the corresponding button on the PAV. Notice
that a yellow LED in the main display lights up briefly after you press a
button. This LED indicates that the PAV is transmitting the command which
corresponds to the button you just pushed. You may repeat this process
until all buttons have been learned.
Tip: save the teaching of the
recall
button for last, since its function
as the menu button’s “double” will result in the on screen display
reverting to the previous menu after it transmits its signal.
4 TO RE-LEARN BUTTONS WHICH EXIST ONLY ON THE REMOTE CONTROL,
CHOOSE “REMOTE ONLY”
From the teach remote menu, select remote only. The on screen display will
now look something like this (see next page):
TEACH
REMOTE
PANEL
BUTTONS
PRESS
BUTTON
REMOTE
ONLY
MENU
ENTER
DISPLAY
ON SCREEN
DIRECT
ACCESS
SURROUND
PATH
MISC
CONTROL
SPECIAL
REMOTE
TRIG ON
REMOTE
TRIG OFF
RE-EQ
ON/OFF
DIRECT
VOLUME
SUB ON/OFF