Filter
Top Products
16
The crossover frequency can be selected anywhere between 40 – 400Hz.
Due to the limited frequency response of most conventional subwoofers we do not
recommend that you select a crossover frequency higher than 80 – 160Hz.
However, with a Lyngdorf Audio 2+2 system you can go as high as 400Hz! Please study
our literature on 2+2 systems or visit our website, see the Support section in this manual.
d. Delay
If you are using a set-up with two main loudspeakers located at an identical distance to the
listening position you don’t need to set a delay. However, if the distance isn’t identical
and/or you are using a subwoofer or a Lyngdorf Audio 2+2 system, you can set a delay in
order to ensure that the sound from each loudspeaker reaches the listening position
simultaneously. This must be done for main left (ML) and right (MR) and, if subwoofers
(sub) are used, also for the line left (LL) and right (LR).
To set the delay all you need do is to measure the distance from each loudspeaker to the
listening position and enter these values in the menu. The necessary delays are then
automatically calculated and applied to each channel.
The above error message is displayed when the entered distances for either channel
(Left/Right) exceed the maximum possible delay in the TDA 2200.
Solutions:
(Can be used individually or together to achieve a valid set-up with respect to the delay
lengths):
• Shorten the distances between your Main and Line channels resulting in a more
compact loudspeaker set-up.
• Arrange your loudspeaker set-up and/or your listening position in a more
symmetrical set-up.