Lyngdorf Audio TDA 2200 Stereo Amplifier User Manual


 
12
6. Rear Panel
Fig 2: TDA 2200 rear panel.
DIGITAL INPUT 1-3 (1)
RCA Connectors for SPDIF input
DIGITAL OUTPUT (2)
Selected digital input is sent – full range or filtered via the DSP - to the Digital Output
connector for daisy-chaining more than one TDA-2200. The sample rate is fixed at 96 kHz.
This output is also active when Analog input is selected.
DIGITAL INPUT 4 (3)
XLR Connector for AES input
OPTICAL DIGITAL INPUT 5 (4)
Connector for Toslink input
ANALOG OUTPUT (5)
DAC output from DSP Section
NOTE! The connectors from 6-10 are only available if the optional AD-Converter card is
mounted
INPUT (6-8)
Single-ended Analog input L/R pairs 1-3
INPUT (9-10)
Balanced Analog input L/R number 4
LOUDSPEAKER TERMINALS (11)
Loudspeaker output, NOTE! All Outputs are bridged and must never be connected to
ground because of the DC offset to Chassis