Filter
Top Products
LES 600 OPERATING INSTRUCTIONS 7
Positioning Your Microphone
After the microphone is connected to the belt-pack Transmitter,
position the microphone as described below:
1 Lavaliere Microphone: The lavaliere microphone should be
hung around the neck as illustrated, resting on your collar
bone. The neck cord is adjusted by squeezing the two long
ends together and then sliding the adjuster up or down the cord.
2 Flexible Collar Microphone: The flexible collar microphone
is wrapped around the neck with the microphone element
positioned 3-4 inches from the mouth, as shown.
3 Noise-canceling Headset Microphone: The headset micro
phone is placed from behind the head over both ears. (Like
putting a pair of glasses on backwards). The microphone
arm is then adjusted up or down to follow along your jaw
line with the microphone element at the end positioned
about 3/4” from the chin as shown. The flat side (with
screwhead) should be facing away from your mouth.
Adjusting Microphone Volume
1 Make sure the Receiver/ Amplifier is switched ON and the
Microphone is securely connected to the Transmitter.
2 Switch the Transmitter to the ON
position. The red POWER indicator
on the Transmitter will flash briefly.
The yellow RF INDICATOR on the
front panel of the Receiver/
Amplifier should light, indicating
that it is receiving the Transmitter
signal and is ready for use.
Step 3
Step 4
Note Feedback or
"squealing" may occur if
the volume is set too high.
Reducing the loudness of
the speakers with the
volume control usually
eliminates feedback.