Filter
Top Products
4 LES 600 OPERATING INSTRUCTIONS
Power for Your LES 600 Receiver/Amplifier
1 Check that:
• Both front panel microphone volume controls (MIC 1
VOLUME and MIC 2 VOLUME) are set to minimum
(turned fully counter-clockwise).
• The Receiver/Amplifier is connected to a power source: Use
the enclosed AC/DC power adapter to plug into a power
cord or a standard wall electrical outlet, and connect the
other end to the DC POWER IN jack on the back panel.
• The speakers are connected as instructed in the Installation
Guide included in your packing box.
2 Turn ON the MIC 1 VOLUME power/volume knob located
on the left side of the front panel of the Receiver/Amplifier.
The red POWER light on the top left
should light up. (If your system has
the optional additional wireless mod-
ule installed, you may turn the Mic 2
Volume power/volume knob on as
well. This knob is located on the right
side of the front panel and has its own
POWER light on the top right that
will light up.)
Note Refer to the
Reference Guide on page
14 to identify the name and
location of each component
of your system.
Familiarizing yourself with
these pages may be helpful
if you are unfamiliar with
electronic equipment.
Operating Instructions
Step1