Filter
Top Products
17 & 19
16 LES 600 OPERATING INSTRUCTIONS
DC Power Connector:
The Receiver/Amplifier requires a 15-volt, 2.4 Amp DC power
supply. The center conductor is positive (+) polarity.
Caution: Power supplies from different manufacturers have various
output voltages, current ratings, and polarity. Connecting the wrong
type of power supply can result in damage to the LES 600.
Transmitter Charging Jacks:
This is used to charge the rechargeable NiMH batteries in the
belt-pack Transmitter and optional Hand-held Microphone.
One end of the charging cable is connected to this jack. The
other end of the charging cable is connected to the BATTERY
CHARGING INPUT located on the side of the belt-pack
Transmitter, or bottom of the Hand-held Microphone.
See previous diagrams on page 5 and 8.
Mixed Audio Output Level Adjust:
Rotating the MIXED AUDIO OUTPUT ADJUST clockwise
increases the level of the audio signal at the Mixed Audio
Output jack located on the back panel.
Mixed Audio Output Jack:
The Mixed Audio Output jack sends to an external source, the
same audio information that is being supplied to the speaker
system. For example, this output could be used to connect to a tape
recorder for recording purposes, or to an assistive listening device
such as LightSPEED’s LES-360 FM Personal Listening System.
13
14 & 15
16 & 18
EQ
Q
EQ
Hi
M
i
d
L
ow
w
Antenna
Antenna
In
p
u
t
In
p
u
t
Level Adjust
Level Ad
j
ust
Tran
s
mitt
er
Char
g
in
g
DC Power In
F1
F2
F3
1
2
3
4
Mixed
Mi
Audio
u
Audio
u
Speaker
Zone
Switch
Speaker
Ouputs
M
i
c
1
M
i
c
2
A
u
x
1
A
u
x
2
Output 1
Output 2
30
29
28
27
26
25
24
23
13
14
15
16
17
18
19
20
21
22