Filter
Top Products
13
Section 4: Adjustments
11/01/12
LR0548, LR0560, LR1560, LR1572, LR1584 & LR1596 Landscape Rakes 302-185M
Table of Contents
Section 4: Adjustments
Angling and reversing
Refer to Figure 4-1:
Six holes are provided for angling the rake in either the
forward or reverse position. The rake can be angled
horizontally 15 degrees to each side of center.
Rake Angling
Figure 4-1
Pitch
The pitch of the rake can be adjusted by lengthening or
shortening the tractor’s 3-Point top center link arm. See
tractor manual to adjust the 3-Point top center arm.
Rake Tilt
The rake may be tilted so one end is lower than the other
by adjusting the tractor’s lower 3-Point arms. See tractor
manual to adjust the lower 3-Point arms.
Gauge Wheels (Optional)
Refer to Figure 2-1 on page 8 & Figure 2-3 on page 9:
1. Remove pin (#6) from yoke shaft (#2).
2. Remove gauge wheel with yoke shaft (#2) from
support arm (#1).
3. Place desired number of spacers (#3 & #4) on the
yoke shaft.
4. Replace gauge wheel assembly (#2) into the support
arm (#1).
5. Place remaining spacers (#3 & #4) on the yoke shaft
above the support arm (#1) and reattach pin (#6).
12058
LR15 Flip Down Blade (Optional)
Refer to Figure 4-2:
The LR15 grader blade may be stored in the up position
when not in use and lowered when needed.
1. Carefully pivot blade upward until it contacts the
blade lock handles (#1). A lock pin (#2) should be
placed in the lower hole to ensure that the grader
blade remains securely in the raised position.
2. Lower blade by removing the lock pin from the lower
hole and replace in upper hole.
3. Pull blade lock handle (#1) to allow grader blade to
flip down.
Grader Blade Lock Up Position
Figure 4-2
15096