Filter
Top Products
10
Section 2: Optional Equipment Set-up
LR0548, LR0560, LR1560, LR1572, LR1584 & LR1596 Landscape Rakes 302-185M
11/01/12
Table of Contents
Grader Blade without Gauge Wheels
Refer to Figure 2-5:
1. Attach blade support arms (#16) to the right and left
side of rake mount (#20) with 3/8" x 2 3/4" GR5 hex
bolts (#17), 3/8" lockwashers (#18), and 3/8" hex
nuts (#19) (six bolts per support arm). Tighten to
proper torque.
2. Attach blade lock handle (#3) to the right and left
blade support arms with 1/2" x 3" GR5 hex bolts (#2),
lock washers (#14), and hex nuts (#15) as shown.
Tighten to proper torque.
3. Insert pin (#1) through the top hole in both blade
support arms. Secure with hair pin (#9).
4. Attach the right and left end of grader blade (#11) to
the blade support arms with 3/4" x 2 1/2" GR5 hex
bolts (#12) and locknuts (#13). Do not torque
locknuts (#13).
Grader Blade Side Plate Assembly
Refer to Figure 2-5:
1. Attach two hex coupler nuts (#8) with flat washer (#6)
to side plates (#7) by inserting 7/16" x 1" GR5 hex
bolts (#4) complete with lock washers (#5), and flat
washers (#6) through the bottom and top holes as
shown. Do not torque until step 3.
2. Insert pivot pin on side plates (#7) through the tubes
located on the back side of grader blade (#11). Make
certain coupler nuts (#8) are positioned behind the
grader blade. Secure pivot pins with hair pins (#9)
3. Adjust hex coupler nuts3 (#8) against back side of
grader blade and tighten bolts (#4) to proper torque.
LR15 Support Stand (Accessory)
Refer to Figure 2-6:
LR15 Series Landscape Rakes with serial number
475594 and higher are factory supplied with a support
stand. You may purchase an accessory support stand
from your nearest Land Pride dealer if the serial number
on your rake is 475593 or below. For additional
information, see “LR15 SupportStand (Accessory)”on
page 15.
Grader Blade Assembly without Gauge Wheel
Right-Hand Side Shown
Figure 2-5
LR15 Support Stand
(Accessory for units with s/n 475593-)
Figure 2-6
20993
25524
Retaining
Pin
Support
Stand