Filter
Top Products
52 CONTENTS TS-590S
8 EXPANSIVE APPLICATION SOFTWARE
This chapter describes the Windows related software to be used to control the TS-590S from a PC.
Following are the Windows related software products that can be used with the TS-590S.
Table 8-1 Windows Related Software for TS-590S
We will provide some typical system configurations using the TS-590S and Windows software.
The microphone connected to the TS-590S and the transceiver’s built-in speaker are used.
8.1 Windows Related Software
Name Description
ARCP-590 This software enables control of the TS-590S from a PC.
ARHP-590
This host program is used on the host station PC when the TS-590S is remotely controlled over
a network. The software is used in combination with ARCP-590.
ARVP-10
This VoIP software is to transfer the TX and RX audio signals when remotely controlling the
TS-590S over a network.
Note: The software is composed of ARVP-10H and ARVP-10R.
ARUA-10
This software enables use of the microphone and speaker of a PC in place of those on the
TS-590S. It enables the audio signal from the PC’s microphone to be transfered via USB audio
and transmitted from the TS-590S. Also, the audio output of the TS-590S can be emitted from
the PC’s speaker via USB audio.
Note:
If you are using a home-made audio cable connected to the ACC2 connector, this software is not
required.
This software is not required if this is used over a network.
Virtual COM Port
Driver
Being installed on the PC, this supports use of ARCP-590 and ARHP-590 after the TS-590S is
connected to a PC with a USB cable.
Note: If the TS-590S is connected to the PC with a serial cable, this software is not required.
8.2 System Configurations
8.2.1 Controlling TS-590S from a PC using the COM Connector
PC
Type of
Connection
TS-590S
Software Hardware Hardware
Control signal ARCP-590 - RS-232C cable * Connected to the COM connector
Audio signal - - No connection
The microphone connected to the
TS-590S and the transceiver’s built-in
speaker