Kenwood TH-K2ET Stereo System User Manual


 
17
BASIC OPERATION
Switching the Power ON/OFF
1 Press [ ] (POWER) briefly to switch the transceiver
power ON.
A high pitched double beep sounds and a Power-ON
message {page 92} appears briefly, followed by the
frequency and other indicators.
2 To switch the transceiver OFF, press [ ] (POWER)
again.
When you turn the transceiver OFF, a low pitched
double beep sounds.
The transceiver stores the current frequency and
parameters when it is turned OFF and recalls these
parameters the next time you turn the transceiver ON.
Adjusting the Volume
Turn the VOL control clockwise to increase the audio
output level and counterclockwise to decrease the
output level.
VOL ENC.
If you are not receiving a signal, press and hold
[MONI/SQL] to unmute the speaker, then adjust the
VOL control to a comfortable audio output level.