Kenwood KRF-V8300D Stereo Receiver User Manual


 
44
KRF-V9300D/KRF-V8300D/KRF-V7300D
Playing music or movie
SPEAKERS
A/B/OFF
LISTEN MODE
INPUT MODE
INPUT SELECTOR
LISTEN MODE
RECEIVER ON
Turning on the powerTurning on the power
1 Turn the connected monitor and player component
ON.
2 Press [RECEIVER ON] (remote control unit) or [ ]
(main unit) to turn on the unit.
Setting the speaker systemSetting the speaker system
Operation available only on the main unit of this unit.
Press [SPEAKERS A/B/OFF] to select the speaker
system(s) to be used.
The speaker system(s) to be used light up.
Speaker system B cannot be selected when the input mode is
"6ch Input".
Selecting the input modeSelecting the input mode
Operation available only on the main unit of this unit.
When playing a component connected to the digital input
terminal (CD(ASSIGNABLE), VIDEO2 or DVD) or the HDMI input
terminal (DVD IN or VIDEO2 IN), set the input mode to match the
type of the audio input.
1 Use [INPUT SELECTOR] to select "CD" (or "VIDEO 1"
or "AUX" which you assigned to CD(ASSIGNABLE)
terminal), "VIDEO2" or "DVD" input source.
2 Press [INPUT MODE] to select the input mode.
Each press switches the mode as follows.
When the HDMI input is disabled:
Display Setting
"Full Auto"
The digital and analog inputs are switched automatically according
to the input signal. When a digital input is detected, the decode
mode is also switched according to the signal type (PCM/Dolby
Digital/DTS).
"Digital Manual"
The input mode is fixed at digital to accelerate the input signal
processing and eliminate lack of audio at the beginning of playback.
The decode mode is also fixed according to the type of the signal
to be played.
"6ch Input"*
1
*
2
The analog 6-channel input mode to be selected when playing the
DVD player connected to the DVD/6CH IN terminal.
"Analog"*
2
The input mode is fixed at analog.
This is selected for playback of analog player components.
*
1
"6ch Input" setting can be selected only when the input
selector is set to "DVD (6ch In)".
*
2
This cannot be selected when in DTS play mode.
When the HDMI input is enabled:
(Input source is set to "DVD" or "VIDEO2" only)
Display Setting
"Signal Auto"
The decode mode is switched automatically according to the digital
signal type (PCM/Dolby Digital/DTS).
"Signal Manual"
The decode mode is fixed according to the type of the digital signal
to be played.
The AUTO DETECT indicator lights when "Full Auto" or "Signal
Auto" is selected.
If the audio is lost as a result of change in the input signal while
"Digital Manual" is selected, press [LISTEN MODE].
Input source keys
Preparation for playing music or movie