Filter
Top Products
24
KRF-V9300D/KRF-V8300D/KRF-V7300D
Connections
Connecting an iPod
The PNC-iP120 (optional) is necessary to connect an iPod to this unit.
For the usable iPod models, see < iPod models usable with this unit> 7.
PNC-iP120 (optional)
L
R
AUX CD MD/TAPE VIDEO1
ANTENNA
VIDEO2
AUDIO
DVD/6CH IN
FRONT SPEAKERS (6 – 16 )
AUTO ROOM EQ
MIC IN
VIDEO1 IN
DVD IN
VIDE
O
VIDEO1 OUT
C
SUB WOOFER
PRE OUT
CENTER
SURROUNDFRONTPLAY INPLAY INREC OUTPLAY INPLAY INPLAY IN REC OUT
SUB WOOFER
S-VID
E
V
RED WHITE GREEN
AM
SPEAKER A SPEAKER B
CENTER
GND FM 75
5V
500mA
iPod
L
R
L
R
SU
R
5V
500mA
iPod
Release buttons
Display when an iPod is connected
When an iPod is connected and the iPod input source is selected,
the display shows the connection status of the iPod.
"Reading" (Blinking):
iPod is being recognized.
"Connected" :
iPod has been recognized. Now this unit can control the
iPod.
"Connect Error" :
The connection is erroneous.
➡ Disconnect the iPod and connect it again.
The iPod in use is not compatible with this unit.
➡ Connect an iPod compatible with this unit by referring
to < iPod models usable with this unit> 7.
The software version of the iPod may be obsolete.
➡ Update the software version of the iPod by referring to
< iPod models usable with this unit> 7.
The battery is low.
➡ Wait until the battery is charged.
"Disconnect" :
The iPod is disconnected.
• Turn this unit OFF (standby mode) before connecting the iPod.
• Insert the iPod connection cable all the way, until it clicks.
• To disconnect the iPod, hold the release buttons on both sides
of the connector of the iPod connection cable and pull the
connector. To prevent damage, do not pull the connector with an
excessive force.
• While the iPod is connected to this unit, the iPod can be
controlled from this unit or the remote control unit provided with
it. When the iPod is connected to this unit, it cannot be used to
control its operations.