Filter
Top Products
17
Operations
KRF-V8010D (En/T)
To adjust the balance
Muting the sound
MUTE lets you mute the sound of the speakers.
Press the MUTE key.
To cancel
Press the MUTE key again so that the “MUTE” indicator goes off.
•Muting can also be cancelled by adjusting the volume.
Blinks
Use the test tone feature. $ - 3
SOURCE DIRECT playback (analog sources only)
Use this function to pass the source material direct to the amplifier,
bypassing any audio processing.
To cancel
Press the SOURCE DIRECT key.
•Either press the LISTEN MODE, SOUND, and SETUP keys, or
switch to another input source to cancel SOURCE DIRECT play-
back.
Listening with headphones
1 Press the SPEAKERS A or B key so that the speaker indicator
goes off.
Make sure the SPEAKERS indicators are turned off.
2 Connect headphones to the PHONES jack.
• If you turn off all of the speakers when in the surround mode, the
mode is cancelled as well, resulting in stereo playback.
3 Use the VOLUME CONTROL (VOLUME) to adjust the volume.
1 Use the input selector to select the source (other than “TAPE”)
you want to record.
2 Set the cassette deck to record.
3 Start playback, then start recording.
Recording audio
Recording video
1 Use the input selector to select the video source (other than
“VIDEO1”) you want to record.
2 Set the video deck connected to VIDEO 1 to record.
3 Start playback, then start recording.
Recording
Recording a music source
1 Press the MONITOR key.
2 Use the input selector to select a source other than “TAPE.”
3 Start playback on the cassette deck connected to the MONITOR
jacks and start recording on the cassette deck connected to the
MD/TAPE jacks.
Copying tapes
1 Use the input selector to select “TAPE.”
2 Start playback on the cassette deck connected to the MD/TAPE
jacks and start recording on the cassette deck connected to the
MONITOR jacks.
MONITOR = TAPE copying
TAPE = MONITOR copying
• To copy tapes using a double cassette deck, refer to the instruc-
tion manual of the double cassette deck.
MONITOR function (analog sources only)
You can connect a cassette deck or graphic equalizer to the MONI-
TOR jacks of the receiver. If a graphic equalizer is connected, the
MONITOR key should be left in the on position. Alternately, if a
cassette deck equipped with a 3-head system is connected to the
MONITOR jacks, you will be able to monitor the just-recorded signal
while making recordings on the cassette deck. By switching the
MONITOR key on and off, you can compare the sound of the source
signal and the just-recorded signal. For more information, refer to the
instruction manual of the connected component.
PHONES
S.DIRECT
TUNED
MEMO.
AUTO
ST.
AUTO SOUND
Press again.
•If SOURCE DIRECT playback was activated when using a sur-
round mode, cancelling it reactivates the previous surround mode.
STEREO
MONITOR
TUNED
MEMO.
AUTO
ST.
AUTO SOUND
Normal playback
C
A
SP
C
D
A
SP
MUTE
SW
R
L
INPUT SELECTOR
MONITOR