Filter
Top Products
16
Operations
KRF-V8010D (En/T)
Normal playback
1
Listening to a source component
2
3
Start playback from the selected source.
* Once setup codes are registered in the remote control, the input
name display changes according to the name of the registered
component.
Example: if you register a VCR at the VIDEO 1 jacks, "VCR" appears
instead of "VIDEO 1". RC2
•When using the remote control after initial setup, any inputs that
have not been registered with a setup code are deleted from the
cyclic list. RC4
•The INPUT SELECTOR on the front panel of the receiver always
cycles through all inputs.
1 TUNER
2 "CD" ("CD"*)
3 "TAPE" or "MD" ("TAPE"*)
4 "PHONO"("PHONO"*)
5 "VIDEO1" ("VCR1"*)
6 "VIDEO2" ("VCR2"*)
7 "VIDEO3" ("VCR3"*)
Adjusting the sound
Adjusting the tone
If a source that is not Dolby Digital is selected, you can adjust the sound
quality when the receiver is in the stereo mode.
1 Press the SOUND key to select the tone mode to be adjusted.
• The bass and treble levels are adjustable from -10 to +10 in 2 step
increments.
•The adjustment item is displayed for approximately eight sec-
onds.
• If you used the remote control to perform the above setting, press
the VIDEO key at this point to turn off the remote control’s own
adjustment mode. In this case, the input source is not switched.
The input sources change as shown below:
Selecting a source using the INPUT SELECTOR knob
Use the input selector (INPUT SELECTOR (AUDIO, VIDEO))
to select the source you want to listen to.
Selecting a source using the AUDIO key on the remote control
Selecting a source using the VIDEO key on the remote control
1 "CD" ("CD"*)
2 "TAPE" or "MD" ("TAPE"*)
3 TUNER
4 "PHONO"("PHONO"*)
1 "VIDEO1" ("VCR1"*)
2 "VIDEO2" ("VCR2"*)
3 "VIDEO3" ("VCR3"*)
4 "<--->" (Not used by this receiver.)
Use the VOLUME CONTROL (VOLUME) to adjust the
volume.
2 Use the MULTI CONTROL (TUNING/SKIP) to adjust the sound
quality.
BASS: Select this to adjust the low frequency range.
(Press the SOUND key once.)
TREB: Select this to adjust the high frequency range.
(Press the SOUND key twice.)
Once-touch low frequency emphasis (bass boost)
If a source that is not Dolby Digital is selected, you can adjust the sound
quality when the receiver is in the stereo mode.
Press the BASS BOOST key.
•Press the key once to select the maximum (+10) low frequency
emphasis setting.
• This key does not function when the receiver is in the sound quality
or ambience effects adjustment mode.
Switching back to the previous setting
Press the BASS BOOST key again.
VOLUME
VIDEO AUDIO
INPUT SELECTOR
VOLUME CONTROL
VOLUME
SOUND
TUNING/SKIP
VIDEO
MUTE
SOUND
MULTI CONTROL
VOLUME CONTROL
SOURCE DIRECT
BASS BOOST
PHONES
SPEAKERS A/B
T
REB +4
STEREO
A
SP
TUNED
MEMO.
AUTO
ST.
SW
R
L