Filter
Top Products
40
KRF-V6300D
Adjustment according to the
playing source
The audio can be adjusted as desired according to the source
being played.
MULTI CONTROL SOUND
MULTI CONTROL
O/
SOUND
SPEAKERS A/B/OFF
œ Press [SOUND] until the desired item appears on
the display.
Each time you press the key, the menu changes as
follows. Note that some items are not displayed
depending on speaker settings and listen mode.
Display Adjustment Range
"C" Center speaker level -10 – +10dB
*
1
"RS" Surround right speaker level -10 – +10dB
"RB"* Surround Back right speaker level -10 – +10dB
"BS"* Surround Back speaker level -10 – +10dB
"LB"* Surround Back left speaker level -10 – +10dB
"LS" Surround left speaker level -10 – +10dB
"SW" Subwoofer level -10 – +10dB
"INPUT" Input level -6, -3, 0 *
2
"NIGHT" Midnight mode "ON", "OFF" *
3
"PANORAMA" Panorama mode "ON", "OFF"
*
4
"DIMENSION" Dimension
"CENTER WIDTH" Center width
Input source name Exit the adjustment mode.
* "RB" and "LB" can be selected when "BS L/R" is selected in
the speaker setup. "BS" can be selected when "BS MONO" is
selected in the speaker setup.
*
1
The adjustment is only temporary for the current input
selection. The value will return automatically to the original
setup value when the power is turned on/off or when the
input selection is changed.
*
2
Analog mode only
*
3
Dolby Digital and DTS mode only
*
4
Pro Logic II Music mode and Pro Logic IIx Music mode only
∑ Use the [MULTI CONTROL ∞/5] to adjust the
setting as desired.
For detailed adjustment method, see the explanation of
each item.
To exit the sound adjustment mode
Press [SOUND].
Speaker level adjustmentSpeaker level adjustment
The output level from the desired speaker channels can be fine
adjusted according to the properties of each disc.
The adjustment is only temporary for the current input selection.
The value will return automatically to the original setup value
when the power is turned on/off or when the input selection is
changed.
œ Press [SOUND] repeatedly until the speaker to be
adjusted ("C", "RS", "RB", "BS", LB", "LS", or "SW")
appears on the display.
∑ Use the [MULTI CONTROL ∞/5] to adjust the level.
é Repeat steps 1 and 2 to adjust the level of other
speakers.
Input level adjustmentInput level adjustment
¶ Analog source only
If the input level of an analog source signal is too high, the CLIP
indicator will blink to indicate. Adjust the input level.
œ Press [SOUND] repeatedly until "INPUT" appears
on the display.
∑ Use the [MULTI CONTROL ∞/5] to adjust the level.
Adjusting the sound