Filter
Top Products
22
KRF-V6300D
Speaker setup flow
The detailed settings below allow you to enjoy full performance
of the receiver according to the environment of your listening
room.
Speaker settings consist of 6 elements.
Speaker Setup ("SP SETUP") £
Select whether each speaker channel is used or, if used, its size.
The Easy Setup function also allows you to make speaker settings
easier.
See <Speaker setup (Easy Setup)> ¡
Test Tone ("TEST TONE") ¢
Select the output level from each speaker.
Distance ("DISTANCE") ¢
Select the distance between each speaker and the listening
position.
Crossover ("CROSS OVER") ∞
Set the lower limit of the bass frequencies reproduced from the
speakers set to "NML" in the <Speaker Setup>. The frequencies
below the frequency set here are distributed to other speakers
(those set to "LRG" and the subwoofer).
Low Frequency Effects Level ("LFE LVL") ∞
Select the level of bass audio enhancement.
Low Frequency Effect channel delivers separate non-directional
bass signals to the subwoofer for more dynamic deep bass sound
effects.
Audio Delay (Lip Sync) ("AUDIO DELAY") ∞
Adjust the deviation in time between the video and audio.
Speaker settings completed!
Getting into the setup mode
The setup procedure is identical for all of the setting elements.
Once you remember the following procedure, you can easily set
up other setting elements.
SETUP
MULTI CONTROL
O/
œ Press [SETUP] to enter the setup mode.
∑ Use [MULTI CONTROL ∞/5] to select the element to
setup.
Display Setting
"SP SETUP" Speaker setup
"TEST TONE" Test tone
"DISTANCE" Distance
"CROSS OVER" Crossover
"LFE LVL" Low frequency effects level
"AUDIO DELAY" Audio delay
"EXIT" Exit the setup mode.
é Press [SETUP] to get into the setup mode of the
selected element.
® Perform setup by referring to the page describing
the selected item.
To exit the setup mode
Select "EXIT" in the step ∑ and press [SETUP].
• The [SETUP] key and [MULTI CONTROL] knob on the front panel
can also be used to select the item in the setup mode.
Speaker setup (Detailed Setup)