Filter
Top Products
12
EN
Connecting the speakers
Setting up the system
SPEAKERS (6-8Ω)
FRONT
CENTER
SURR BACK / SW
R LSURR
R
L
Front Speakers
Surround Speakers
Be sure to connect both surround speakers
Surround Back Speaker
When the surround back speaker is
connected to these terminals, set
the speaker setting to
"BS/SW
BS".
)
In this case, the subwoofer should
be connected to the PRE OUT
SUBWOOFER jack. $
Subwoofer
When the subwoofer is connected
to these terminals, set the speaker
setting to
"BS/SW
SW
".
)
In this case, two surround back
speakers should be connected to
the PRE OUT SURROUND BACK
jacks. $
Center
Speaker
LeftRight
Left
Right
Whether each speaker is connected properly can be
confirmed by outputting the test tone and checking if
each speaker channel outputs audio. For details, see
"Speaker settings" (Step
6 Adjust the speaker volume
level). )
CAUTION
Make sure that the power cord plug is disconnected from the AC
wall outlet before proceeding to speaker cord connections.
If the conductor wires on the extremity of speaker cord are
untwisted, there is a risk of short-circuiting. Be sure to twist
them well before connecting the speaker cord.
Protection circuitry
This unit incorporates protection circuitry, which may be activated
during high-power reproduction or in case of extreme rise in tempera-
ture.
When the protection circuitry is activated, the output from this unit is
shut down and the STANDBY indicator blinks.
In this case, turn this unit OFF then ON again and reduce the output
volume level.