Filter
Top Products
50
Additional Information
Remote control unit
Cause
• The batteries are nearing exhaustion.
• Subwoofer is OFF.
• No setup codes registered at for the respective
input(s).
• The remote control is set to a different operation
mode.
• Batteries are exhausted.
• The remote control unit is too far away from the
main system, controlling angle is too large, or
there is an obstacle between the receiver and
the remote.
• The audio cords and system control cords are
not connected properly.
• No software is loaded in the source component.
• An attempt is made to play a tape which is being
recorded in the cassette deck.
• The remote control has not been set to the
operation mode for the component you wish to
control.
• The microprocessor of the remote control mal-
functions.
Remedy
• Replace with new batteries to preserve the
currently registered setup information. (
• Turn the subwoofer ON. ™
• Register a setup code or Non-IR code at the
respective input(s). fl
• Press the MUSIC, MOVIE, or TV keys to select
the appropriate operation mode.
• Replace with new batteries. (
• Operate the remote control unit within the con-
trollable range.
• Connect properly referring to “Setting up the
system”. 7
• Place software in the source component you
want to play.
• Wait until recording has completed.
• Press the MUSIC, MOVIE, or TV keys to acti-
vate the operation mode for the component you
want to control before operation. ¡
• Reset the microprocessor. o
Symptom
The battery indicator flashes during opera-
tion.
Subwoofer volume cannot be adjusted.
Certain inputs cannot be selected using the
remote control.
Remote control operation is not possible.
In case of difficulty
*510/40-52/EN 3/15/01, 12:00 PM50