Filter
Top Products
41
Remote Control
5 From the remote control unit of the other source, press the key
that you want to store.
• When it takes for more than 5 seconds or the remote control unit does
not receive the remote control code well, “Error” appears in the
display. In this case, re-operate from step 1.
6 The remote control code is stored on the key of the remote
control unit.
To delete the memory stored on the key
Press the display operation 1 [Clr] key in step 4. “Cleared”
appears in the display.
The memory previously stored is cleared.
To operate other components
1 Press the MUSIC, MOVIE, or TV key to select the desired input
source.
2 Press the desired key.
1 Point the infrared ray system part of the other remote control
unit to the remote sensor of the remote control unit .
Storing on the memory
2 Press the MUSIC, MOVIE, or TV key to select the input of the
desired remote control unit.
You can store on the remote control unit up to 5 memories.
VCR
Video1:
Menu
Selected input
3 Press the LEARN key.
• The Extend selecting display appears.
>Extend2
>Extend1
Home Enter
Infrared ray system part
Remote control
unit of the other
source.
+
—
+
—
>Extend1
Complete
• When the setup code is not registered, any messages do not appear.
When the setup code is registered
4 Press the 5/∞ keys to select the location.
• Extend1 – Extend5 are available.
5 Press the display operation 2 [Enter] key.
• The remote control is sent for receiving the remote control code.
>Extend1
Waiting
Clr Exit
6 From the remote control unit of the other source, press the key
that you want to store.
• The remote code is sent to the remote control unit.
•“Complete” appears when finished.
• When it takes for more than 5 seconds or the remote control unit does
not receive the remote control code well, “Error” appears in the
display. In this case, start from the step 1 again.
7 The remote control code is stored on the memory (Extend1 –
Extend5) of the remote control unit.
To operate other components by using the stored memory
2 Press the display operation 2 [Menu] key during “Menu” ap-
pears in the display.
• The Menu display appears.
3 Press the 5/∞ keys to select the memory you want to operate.
4 Press the display operation 2 [Enter] key.
To delete the stored memory
Press the display operation 1 [Clr] key in step 5. “Cleared”
appears in the display and the memory that is selected in step 4
is erased.
1 Press the MUSIC, MOVIE, or TV key to select desired input
source.
>Extend1
Complete
Extend 1
You can restore the setup codes or memories to their original default
settings.
•“Cleared” appears in the display, and the remote settings return to
their original default settings.
5
2
Insert the batteries while pressing and holding the
5
key
and
2
key.
Restoring the original factory settings
Remote control operations
• The remote code is sent to the remote control unit.
•“Complete” appears when finished.
• To maintain the memory settings, complete the battery replacement
operation approximately within 10 minutes.
*510/40-52/EN 3/15/01, 12:00 PM41