Kenwood VR-510 Stereo System User Manual


 
22
Preparations
1 Press the SET UP key such that the subwoofer setting indica-
tion SUBWOOFER scrolls across the display.
“SUBWOOFER” will be scrolled from right to left
Blinks
When you operate on the remote control unit
11
11
1 Press the display operation 2 [Menu] key repeatedly until
01.IR” appears in the display of the remote control unit.
22
22
2 Press the 5/ keys to select “02.Surround”, then press
the display operation 2 [Enter] key.
2 Use the MULTI CONTROL knob or 5/ keys to select the
appropriate subwoofer setting.
1 ON : Subwoofer setting mode to the receiver is ON.
2 OFF : Subwoofer setting mode to the receiver is OFF.
The initial setting is “SUBWOOFER ON”.
When “SUBWOOFER OFF” is selected, the front speakers are
automatically set to “LRG” and the procedure skips to step 5.
When subwoofer output sound is required, select “FRONT NML”.
Preparing for surround sound
To enable you to obtain optimum enjoyment from the receiver’s listening
modes, make sure to complete the speaker settings (subwoofer, front,
center, and surround speakers) as described below.
+
+
MULTI CONTROL
SET UP
SYS. POWER ( )
Display operation 1
Display operation 2
5/
POWER ( )
1
2
Speaker settings
>02.Surround
>01.IR
Home Enter
SetUp
Home Next
FM
AM
MHz
kHz
PRO LOGIC
3
DOWN MIX
DIGITAL
S.DIRECT
MONITOR
DSP
MEMO
ST.
TUNED
AUTO SOUND
AUTO
C
S
RS
TI.VOLB
CLIP MUTE
RDS EON PTY
TP TA NEWS
R
SP A
STEREO
LS
SW
Blinks
4 Use the MULTI CONTROL knob or 5/ keys to select the
appropriate front speakers setting.
1 NML/THX (normal) : Average size front speakers are
connected to the receiver.
2 LRG (large) : Large front speakers are connected to
the receiver.
Under certain circumstances , for “FRONT LRG” selection, no sound
will be heard from the subwoofer even when it is set to ON. However,
if you select SW RE-MIX ON when subwoofer is selected, you may
hear sound from the subwoofer.
5 Press the SET UP or display operation 2 [Next] key to accept
the setting.
The center speaker setting indication “CENTER” scrolls across the
display.
If you have selected “NML” as the front speakers setting,
1 NML/THX :Center speaker setting mode to the receiver
is ON.
2 OFF : Center speaker setting mode to the receiver is
OFF.
7 Press the SET UP or display operation 2 [Next] key to accept
the setting.
The surround speaker setting indication “SURROUND” scrolls
across the display.
8 Use the MULTI CONTROL knob or 5/ keys to select the
appropriate surround speaker setting,
If you have selected “LRG” as the center speaker setting,
1 NML/THX (normal) : Average size surround speakers are
connected to the receiver.
2 LRG (large) : Large surround speakers are con-
nected to the receiver.
3 OFF : Surround speaker setting mode to the
receiver is OFF.
If you have selected other than “LRG” as the center
speaker setting,
1 NML/THX : Surround speaker setting mode to the receiver is
ON.
2 OFF :Surround speaker setting mode to the receiver
is OFF.
9 Press the SET UP or display operation 2 [Next] key to accept
the setting.
The subwoofer remix setting indication “SW RE-MIX” scrolls
across the display.
Select the subwoofer re-mix setting.
1 Use the MULTI CONTROL knob or 5/ keys to select the
appropriate subwoofer remix setting.
1 ON : Subwoofer re-mix set mode to the receiver is ON.
2 OFF : Subwoofer re-mix set mode to the receiver is OFF.
This is the THX preferred setting.
6 Use the MULTI CONTROL knob or 5/ keys to select the
appropriate center speaker setting.
If you have selected “LRG” as the front speakers setting,
1 NML/THX (normal) : An average size center speakeris con-
nected to the receiver.
2 LRG (large) : A large center speaker is connected
to the receiver.
3 OFF : Center speaker setting mode to the
receiver is OFF.
MEMO
ST.
TUNED
FM
AM
MHz
kHz
PRO LOGIC
3
DOWN MIX
DIGITAL
S.DIRECT
MONITOR
DSP
AUTO SOUND
AUTO
CLIP
LFE SW
S RSLS
B
MUTE
TI.VOL
RDS EON PTY
TP TA NEWS
STEREO
C
SP A
L R
Blinks
3 Press the SET UP or display operation 2 [Next] key to accept the
setting.
The front speakers setting indication “FRONT” scrolls across the
display
3
Turn on the power to this receiver by pressing POWER
(
) or SYS. POWER ( ) key.
Select a speaker system.
Continued to next page
DIGITAL
S.DIRECT
MONITOR
DSP
MEMO
ST.
TUNED
AUTO
LFE
C
S
RSLS
TI.VOLB
CLIP MUTE
RDS EON PTY
TP TA NEWS
SP A
STEREO
SW
*510/22-23/EN 3/15/01, 11:41 AM22