Filter
Top Products
— 43 —
Do not use any accessories other than those provided with
your unit. If you use other accessories, you may damage the
2CAUTION
Accessories
1. To prevent a short circuit, remove the key from the ignition and
disconnect the - battery.
2. Make the proper input and output wire connections for each unit.
3. Connect the speaker wires of the wiring harness.
4. Connect the wiring harness wires in the following order: ground,
battery, ignition.
5. Connect the wiring harness connector to the unit.
6. Install the unit in your car.
7. Reconnect the - battery.
8. Press the left part at the upper side of the faceplate once to
make the faceplate control panel appear.
• If your car's ignition does not have an ACC position, connect
the ignition wires to a power source that can be turned on
and off with the ignition key. If you connect the ignition wire
to a power source with a constant voltage supply, as with
battery wires, the battery may die.
• If the console has a lid, make sure to install the unit so that
the faceplate will not hit the lid when closing and opening.
• If the fuse blows, first make sure the wires aren’t touching
to cause a short circuit, then replace the old fuse with one
with the same rating.
• Do not let unconnected wires or terminals touch metal on
the car or anything else conducting electricity. To prevent a
short circuit, do not remove the caps on the ends of the
unconnected wires or the terminals.
• Connect the speaker wires correctly to the terminals to
which they correspond. The unit may be damaged or fail to
work if you share the - wires or ground them to any metal
part in the car.
• After the unit is installed, check whether the brake lamps,
blinkers, wipers, etc. on the car are working properly.
• Insulate unconnected wires with vinyl tape or other similar
material.
• Some disc changers need conversion cords for connection.
See the section on "Safety Precautions" for details.
2CAUTION
Installation Procedure
• Mount the unit so that the mounting angle is 30° or less.
.........1
1
.........1
2
.........1
4
.........2
5
.........2
6
.........1
8
.........1
9
External view
......... Number of items
.........1
0
External view
......... Number of items
.........1
7
.........2
3
KDC-X917(K)_U.S_r3 00.12.26 1:13 PM Page 43