Filter
Top Products
— 31 —
Make sure that the unit is installed securely in place. If the unit
is unstable, it may malfunction (for example, the sound may
skip).
NOTE
Bend the tabs of the
mounting sleeve with
a screwdriver or similar
utensil and attach it in
place.
Accessory2
Metal mounting
strap
Phillips truss
head sheet
metal screw
(commercially
available)
Firewall or metal support
Accessory4
Installation (non-Japanese cars)
■
Installation (non-Japanese cars)
To attach this unit, make sure the front of the control panel faces
you and fit it into the mounting sleeve by pressing the four corners
of the hard rubber frame at the same time.
Do not apply strong pressure to other sections than the corners;
otherwise troubles such as the impossibility of opening or closing
the panel may result.
2CAUTION
Refer to the section "Removing the faceplate (page 12)" and
then reattaching the faceplate.
Never insert the taptite screws (ø2 × 4 mm) in any other screw
holes than the one specified. If you insert it in another hole, it
will contract and may cause damage to the mechanical parts
inside the unit.
2CAUTION
3
Locking the faceplate to the unit
If you want to lock the faceplate to the unit so that it does not
fall off, follow the directions below.
Refer to the function "Removing the faceplate (page 12)" and
remove the faceplate.
Insert the provided screw into the hole at the center of the
bottom side of the faceplate which you have removed from
the unit.
2
1
Accessory7
Locking the faceplate to the unit
■
KDC-V7017_U.S r5 00.12.26 1:01 PM Page 31