Filter
Top Products
If you have preset the name of a disc that you want to listen to
in the disc changer, you can look for it by name and start
playing it.
Press the DNPP button on the remote.
"DNPP" will appear in the display, and the disc name preset
play mode is entered.
The names of all the discs in the disc changer will appear
successively in the display for five seconds each.
Discs whose names have not been preset will appear as "NO
NAME" in the display.
• This function can only be used in disc changers that were
manufactured or sold as of 1997. Also note that some units
NOTE
1
Disc Name Preset Play (DNPP)
(Function of Remote)
Press the NAME.S button.
The disc name is stored and the disc name preset mode is
canceled.
If you make no entry in a 10-second period, the name will be
stored with the characters input so far.
• The number of discs whose names can be stored will differ
depending on the disc changer that is connected. Please see
your disc changer manual for details.
Up to 30 CDs can be registered with this unit.
• Discs are identified by their total length and number of tracks. If
another disc happens to have the same specifications as one
that you have already stored a name for, the name will be
displayed for it, too.
• If you want to change the name of a disc, repeat steps 1 and 2
to display the name, and then repeat steps 3 and 4 to input the
changes.
• Pressing the reset button erases the disc names stored in this
unit, but does not erase the names stored in a disc changer.
NOTE
6
Store the names of discs to be displayed when played.
Play the disc whose name you want to preset.
• This function is not available for disc changers that do not
feature the Disc Name Preset function.
• The disc name preset function cannot be used when the
Magazin random play and disc title or track title is displayed.
Press the NAME.S button for at least two seconds.
"NAME SET" is displayed and the disc name preset mode is
entered.
The cursor blinks in the position where character input can be
made.
Press either the 4 or ¢ button to move the cursor to the
desired position.
The 4 button moves the cursor to the left, and the ¢
button to the right.
Each time the 38 button is pressed, the characters to be
entered change as listed below.
Press the DISC
+ or DISC– button to display the desired
character.
Characters that can be displayed are as follows.
Continue steps 3 and 4 until all the characters are chosen for
the name.
You can enter up to 12 characters for each name.
NOTE
5
Alphabet (upper case): A ~ Z
Alphabet (lower case): a ~ z
Numerals and symbols: 0~9 @ ” ‘ ` % & ∗ + - = , . / \ < > [ ]
Special characters: á
àéèíìóòúùÑǮߋflâäê
ë
î
ïôöûüñç©Æ›fi
4
3
2
NOTE
1
Presetting Disc Names (DNPS)
CD/External disc control features
— 20 —
English
KDC-V7017_U.S r5 00.12.26 1:01 PM Page 20