Kenwood AX-7 Stereo System User Manual


 
66
EN
Preparations
Basic section
Application section
Knowledge section
Timer operation
Setting the timer program
(PROG. TIMER)
In each of PROG. 1 and PROG. 2, the timer data including the operating period and played contents can be
programmed and set to be activated or deactivated.
Adjust the clock before setting the timer
£
Connect the related equipment under reference to "System connections"
8~@
1
Make preparations for timer.
Listening to external input sources
Listening to DVD/CD
Listening to radio
Set a disc.
(Only normal playback is possible.)
Radio stations should be preset
beforehand.
Set the timer for a component
connected to external input jacks.
÷ Set the POWER switch of the M-AX7 to the ON position.
÷ The programs of "PROG.1" and "PROG.2" can be activated at the same time.
÷ For the simultaneous programs setting, keep the time intervals of 1 minute or more between timer programs, in order
to avoid time overlapping.
2
Set the timer setting program number.
1Press the MODE key, turn the INPUT SEL./
MULTI CONTROL knob to select "TIMER
SET". Then press the SET key.
2Select "PROG.1 SET" or "PROG.2 SET".
3Press the SET key.
Switching as shown below is done each time the
knob is turned.
"PROG.1 SET"
"PROG.2 SET"
L
R
30 10 5 3 1 0
(-dB)
1
12345
÷ The previously set contents are displayed. (If you do
not want to change them, simply press the SET key.)
÷ When a timer setting has already been made in the se-
lected timer, the setting will be overwritten by the new
setting.
*5613/65-71/EN 06.1.6, 0:54 PM66