Filter
Top Products
51
EN
Preparations
Basic section
Application section
Knowledge section
Option settings for external recording
Setting D.EQ RecMode (digital equalizer recording mode)
1Press the MODE key, turn the INPUT SEL./
MULTI CONTROL knob to select “D.EQ
RecMode”. Then press the SET key.
2Turn the INPUT SEL./MULTI CONTROL
knob to select “D.EQ ON” or "D.EQ OFF".
Then press the SET key.
"DIGITAL EQ REC": The sound is recorded with
the MANUAL EQ settings. ª
Switching as shown below is done each time the
knob is turned.
"D.EQ ON" :
The digital equalizer effect is reflected
in the recorded sound.
"D.EQ OFF" :The digital equalizer effect is not re-
flected in the recorded sound. (Initial
setting)
÷ The settings for D-Bass, TONE, and ROOM
EQ do not influence the recording.
÷
In order to prevent clipping of the digital signal, record-
ing is done with a slightly lower volume. It is possible to
adjust the recording level so that no clipping is done,
while looking at the level meter. (Setting the record-
ing level)
Setting the recording level
1Set the recording pause condition.
2Press the MODE key, turn the INPUT SEL./
MULTI CONTROL knob to select “REC
LEVEL”. Then press the SET key.
3Turn the INPUT SEL./MULTI CONTROL
knob to adjust the recording level. Then
press the SET key.
÷
The level can be adjusted in the range from -8 to +6.
The actual recording level can be confirmed at the level
meter.
*5613/46-51/EN 06.1.6, 0:54 PM51